QualiEco FAQs
Know everything about us, our services, our methods, manufacturing related issues etc. by browsing each FAQ category one by one. - FAQs - PCB Panel Sizes and Panelization
- What panel size would you prefer if I want to panelize myself?We prefer near A4 (around 210mmx280mm) size as a panel. However, provided our manufacturing optimization is not hugely compromised (e.g. only two stack of panels is possible on a 4 spindle drilling machine etc..), there is no restriction in choosing your own panel sizes to suit your requirement.
- Can I put multiple designs onto a single panel for manufacturing?This is called “Multipanel” category of manufacturing. We do not entertain “Multipanel” category and normally try to avoid it.
- How much gap should I keep between boards if I wish to panelize myself?2mm for routing and 0.5mm for v-grooving. This gap should be measured from the center of the cut marks
PCB Design Tips
When designing a PCB, try to limit
the amount of draws you use.
Draws use a lot of memory and slows the programming time. Ex.: Use a flash for pads instead of draws. If for some reason we need to increase or decrease that pad size, it can easily be done by changing the D-code but if they are done with draws it could be a nightmare.
Learn more
What our client says?
QualiEco Circuits Limited has the potential to be an excellent supplier to us! We appreciate the quality of service and support that we receive from QualiEco Circuits. Always deliver what is promised.
Susan ChuardQuality Assurance Supervisor